:
IoT Node(A) is one of Docker Pi series modules.
IoT Node(A) = GPS/BDS + GSM + Lora.
I2C directly controls Lora, sends and receives data, controls the GSM/GPS/BDS module through SC16IS752, the mainboard only needs I2C support.
Support Raspberry Pi and other similar products.
Features:
Docker Pi Series
Programmable
Control directly(without programming)
Extend the GPIO Pins
GPS/BDS Support
GSM Support
Lora Support
Can Stack with other Stack board
Independent of the mainboard hardware (require I2C support)
Specifications:
GPRS section
1. Low power consumption, standby sleep current <1mA
2. Support GSM/GPRS, four frequency bands, including 850, 900, 1800, 1900MHZ;
3. GPRS Class 10;
4. Support GPRS data service, maximum data rate, download 85.6Kbps, upload 42.8Kbps;
5. Support standard GSM07.07, 07.05 AT commands, and access the serial port through I2C interface conversion.
6. AT commands support standard AT and TCP/IP command ports
GPS section
1. Support BDS/GPS joint positioning
2. Support A-GPS, A-BDS
3. Support standard SIM card
LORA section
1. Transmission distance:500 Meters (RF parameters: 0x50 @ China City)
2. Support FSK, GFSK, MSK, GMSK, LoRaTM, and OOK modulation methods
3. Ultra-high receiver sensitivity as low as -141 dBm
4. Support preamble detection
5. Packet engine with CRC, up to 256 bytes
6. LORA transceiver indicator
7. Easy TX/RX by Docker Pi
Mechanical Drawing
