Gates GT2 (or 2GT) belts are compatible with our full range of timing pulleys and idlers.
The Gates RF model is the most widely used due to its dust-proof property and vibration-reducing effect.
Gates Corporation has been a pioneer in power transmission and fluid power solutions for over 100 years, and among its range of high-quality products, Gates drive belts are considered unbeatable.
Gates belts are characterized by:
Made of fiberglass-reinforced rubber, which is resistant to chemicals, more wear-resistant and does not stretch under stress.
Padded with a nylon fabric that covers the belt compound and acts as both a wear-resistant surface (protecting the teeth) and an added grip.
A uniquely designed tooth profile distributes stresses throughout the belt, enabling it to withstand greater loads
Has a 25% higher power rating than previous Poly Chain GT2 belts
Quiet, compact and durable.
This Gates belt model can work at speeds up to 10,000 rpm, with peripheral speeds up to 80 m/s (80,000mm/s).
No lubrication or retensioning is required, which allows for operational continuity during printing. The maximum operating temperature is +85°C (+185°F), so it can be used without problems in 3D printers with a closed chamber.
Package contains: 1m x GT2 Powergrip Gates strap H 6mm model RF (ANTISTATIC)
Can be purchased in multiples of 100 cm, e.g. 1x quantity = 1 m or 1000 mm - 2x quantity = 2 m or 2000 mm
For purchases exceeding the unit, goods will be shipped in one piece equal to the quantity purchased at the customer's request.
