The operation can be made easier by slightly heating the work surface before removal. Helping yourself with a squeegee slowly lift the LokBuild from one corner. Then grasping the raised flap with one hand and with the other hand holding the mold plane apply steady force until the LokBuild to be replaced is completely removed. Use gloves to avoid injury, especially if working with glass planes that may break during adhesive removal. Be careful not to tug during removal as this may damage the printing plate. It usually does not leave any residue, should there be any adhesive residue left on the printer table remove it with alcohol or specific adhesive removal products. At this point with the printbed restored and clean, you can proceed to apply the new LokBuild.

Once removed, LokBuild cannot be reused because removal damages the adhesive.