Wet 3D printing filament can cause various types of problems. In fact, many of the problems that hotend or nozzles are blamed for can be traced back to filament that has absorbed too much moisture.
This product is 10 times more powerful than silica gel and is non-toxic!
It creates a relative humidity (Rh) gradient sufficient to absorb both surface moisture and water particles captured within the filament.
The stainless steel container is perfectly sized to fit the center of the filament spool.
100% Made in USA
To use, simply remove the outer shrink wrap and remove the cap, then insert into the center of the filament spool.