Upgrade your 3D printer Creality with the Revo so you can change cold nozzles without special tools and hot clamping problems.
No other mounts or adapters needed: M3 pre-drilled holes match the X carriage mounting pattern of Creality for easy installation.
No firmware changes: This kit includes a special Revo HeaterCore with a 100K NTC thermistor, which has the same response as the standard thermistor Creality.
Includes solderless, crimpless, butt-jointed connectors for easy connection. Connect the HeaterCore to your 3D printer Creality without unraveling the entire cable harness.
Mounting holes Creality. Convenient M3 holes match the X carriage mounting pattern of Creality, so you can start printing quickly without additional brackets or adapters. Just reuse the existing M3 bolts!
Easy nozzle replacement. A variety of Revo nozzles increases the capabilities of your 3D printer without a difficult nozzle replacement process. Each Revo nozzle can be changed by hand. No tools, no hot clamping.
Easy and hassle-free connection. A number of solderless, crimpless, butt-jointed connectors are included for easy connection, so you can be up and running quickly without having to unravel the entire cable bundle.
Improved reliability. Revo nozzles are sealed at the factory, so there is much less chance of leakage and no hot tightening is required.
Improved efficiency. The included Revo HeaterCore makes your 3D printer heat up faster and more efficiently than the standard HotEnd. Start printing right away without annoying firmware adjustments: a 100K NTC thermistor has been integrated into this special HeaterCore. This thermistor has the same response as the standard HotEnd, so no firmware changes are necessary.
Increased safety. Because of the PTC behavior built into the heaterCore, Revo CR will add additional security against thermal runaway to your Creality 3D printer-providing an extra layer of protection if thermal runaway protection is disabled in the firmware.
Revo CR is directly compatible with the following Creality 3D printers:
Ender 3 / Ender 5 Pro / CR10S / Ender 3 Pro / Ender 5 Plus / CR10S4 / Ender 3 V2 / Ender 6 / CR10S5 / Ender 5 CR10
Please note:
- Revo CR can be used with other Creality printers that use the NTC thermistor, however, changes may need to be made to the holder and/or Z sensor.
- The Z height may need to be adjusted when changing nozzles.
- Please check if your specific printer operates on 12V or 24V before purchasing and mounting.
