SuperVolcano 80W Heater - E3D

These 80W cartridges are designed specifically for the SuperVolcano and provide the power needed to achieve the maximum possible range.
These extra-long 47.50mm cartridges run the full length of the SuperVolcano block.
The 12V cartridge comes with a MOSFET as the current draw is up to 8A
The 24V cartridge does not come with a MOSFET as the current draw is only 3.9A

Please note:
The 12V cartridge draws up to 8A, which is more than most controller boards can handle. Therefore it cannot be used without the included MOSFET switch that will handle the high current draw.
Do not use this cartridge with any other block other than the SuperVolcano heated block.
Use of this cartridge with another block may result in catastrophic system failure.
Be very careful when bending the wires, ideally use a round shape to provide a bend radius that avoids breaking the wires. Also, make sure there is a low pull so as not to fatigue the wires by bending them repeatedly as this will cause a failure.