Rear housing for DDX v3 extruder from Bondtech.
Extended compatibility:
- Fits the hotend Micro Swiss in your DDX
- Fits all previous models, as well as Ender-6 and PrintMill
All DDX V3 units being shipped now include this component.
Made of SLS-molded PA12 (nylon), easy to install. With this housing, the DDX v3 is even easier to install. The fan can be attached to the cover without the use of screws. The duct height can be adjusted with a front-access screw.
Improved mounting of leveling sensors The rear housing of the DDX v3 has also been designed to provide better support for mounting leveling sensors. It now features 2 pressure pockets for square nuts to better grip the screws that hold the sensor mounts.
Also compatible with Ender-6
This rear housing for DDX is designed to extend compatibility with Creality Ender-6.
Get creative
Like previous versions, the DDX v3 also has 3 pockets for inserting square press-in nuts to allow 3 different mounting points on the top back of the extruder. These can be used to mount a filament sensor, break-out board, or simply for an aesthetic addition.
Compatible with hotend Micro Swiss
This back housing for DDX retains the v2 feature to fit the hotend Micro Swiss metal compatible 3D printers Creality. To use a compatible metal hotend with Creality from Micro Swiss on the DDX, the DDX to Micro Swiss adapter is required.
Package contains:
1 x 10079-3v3 DDX v3 Rear Housing SLS 5 x M3 square nut
1 x 4mm push-fit collar
NOT included in this set are:
- Needle roller bearings
- Ball bearings
- Shafts
- Other replacement parts...
