This extruder upgrade kit for the Raise3D N1 / N2 / N2+ printer fits dual and single nozzle printers. It allows for more reliable printing with all types of filament, both rigid and flexible, and the Dual-Drive system ensures that the extruder never loses its grip on the filament.
The original extruder configuration on Raise3D is 532g for the single configuration, this new upgrade is 252g with the included motor and allows for faster printing without surface issues due to vibration during acceleration/deceleration.
The kit comes with its own motor.
The extruder comes with a 4mm ptfe tube plug-in connector that will allow you to connect your existing guide tube to the extruder. The tube is not included.
It installs in about half an hour with the standard tools available.
This upgrade fits both Revision 1 (cast) and Revision 2 (cnc milled) versions of the printhead.
Installation is done in about 20 minutes. No need to cut and solder wires. E-step value: 415
IMPORTANT!
We have learned that if the ribbon cable from the break-out board is disconnected when the printer is on, a thermal run could occur, make sure the ribbon cable is held securely in place with hot glue or a cable tie.
