Upgrade your eXtruder Creality and DDX Direct Drive with a complete original Copperhead hotend to PHase 3.
Turn your Creality hotend into an all-metal one.
Stops problems created by deformation of PTFE when using temperatures above 220°C.
Improves heat dissipation capability.
Uses retractions as short as the nozzle diameter.
Nozzle not included.
Standard nozzles do not fit this hot block. You must upgrade your nozzles to the RepRap standard:
M6x1x7.5 × 12.5
This DDX set is the right configuration to upgrade the stock hotend to PHase 3, with a complete and original Copperhead hotend? on any Creality using the Bondtech DDX Direct Drive eXtruder.
The product comes with a screw-mounted aluminum heat sink, a standard copper and W2S plated stainless steel thermal switch, a nickel-plated copper hot-block, a PA6 laser sintered DDX adapter for Copperhead? and a brass thermistor.
When changing nozzles with this hotend, you must immobilize the heated block before rotating the nozzle. Forcing the nozzle on or off without restraining the heated block can cause severe damage to the thermocouple.
