The next generation Proto-ScrewShield is a dual-purpose prototyping shield.
Not only does it have a large 0.1" grid prototyping area but it also extends the Arduino pins to sturdy, secure, and dependable screw terminal blocks. You even get a few bonus terminals for extra GND and four 'free' terminals for whatever connections you wish!
stackable wing design allows you to slip this under any shield and still get east access to the analog and digital ports of the Arduino - can be stacked above or below pretty much every other shield!
Plenty of prototyping space, with power/ground rails
Diffused green power LED, extra diffused red LED for user choice (although we suggest to connect it to pin 13)
Reset button
2 sets of 6-pin stacky female header pins
2 sets of 8-pin stacky female header pinsComes as a kit of all through-hole parts. You'll need to assemble the kit using a soldering iron, diagonal cutters and solder but its an easy kit and should take less than half an hour. For more information, instructions, and tips check out the Screwshield page
Lots of 3.5mm terminal blocks to fill 36 breakouts on the board
Comes as a kit of all through-hole parts. You'll need to assemble the kit using a soldering iron, diagonal cutters and solder but its an easy kit and should take less than half an hour. For more information, instructions, and tips check out the Screwshield page
